![]() If you select a 24 hour turnaround to go with the mix bus processing, we will put you as a priority but cannot promise that a 24 hour turnaround will be guaranteed. This service cannot be used alongside 24 hour turnaround masters.If a track is not ready for analog processing we will send you back detailed advisories to change/ fix before we begin.We will use a digital EQ to do any clean ups that are needed prior to analog processing if the track needs it.Processing to your mix bus are subtle so please bare that in mind, the goal of this is to enhance your premaster rather than do major fixes to it. Dynamic Pultec EQ curves Wouldnt it be great if the Pultec boost/cut performance would be program dependent Sort of expanding and compressing according to.If there is an issue on our side w will offer a free revision. There are no revisions for this service as it is 100% analog and we will not be saving the settings.Where they differ, however, is in how a signal is routed to them. Like subgroups, they can receive their input from a mix of channels, and typically output to the master bus. Please remove all processing from your master channel including compressors and limiters Auxiliary channels also known as aux channels, auxes, return channels, FX channels, or perhaps something else, depending on your DAWare similar to group buses.Like every other part of mixing, stick with small movements, especially on a mix bus. Or if your cymbals need a bit of shimmer, use a mix bus EQ. If a group of vocal tracks together create an overpowering feel, you can bus them to an EQ track and cut or boost. When exporting/ bouncing, make sure dithering and normalising is turned off. Mix bus EQing is helpful for making small tweaks to a group of tracks as a whole.Provide 1 stereo premaster at either 44.1khz or 48khz, 24bit.Ensure you allow plenty of headroom for us (ideally -6db).Next adjust the threshold while looking at the gain reduction caused by the compressor. Start with a low ratio 2:1 is often plenty. Setting these two parameters is quick and straightforward for mix bus purposes. Make sure you are 100% happy with your mix before you send us the premaster The first thing to do when setting a compressor on the mix bus is choose the ratio and threshold.If there is an issue with the service that is caused by our engineers such as clicks, pops or skips, then free revisions are of course included. As this is an analog process, revisions are not included and will have to be re-uploaded as settings are not saved for this service. You must choose 1 analogue process from each stage below: EQ, Saturation, Compression. If needed, we may use a digital EQ to clean up your premaster so that the mix is balanced before going through the analog chain. Once you are happy with how your track sounds, please choose 3 different analogue processes you would like us to use and we will decide which order is best in terms of signal flow. And the Boost/Cut region gain tools What. So whether you choose us as your Mastering Engineer or not, we want to provide a service where you can run your premasters through a 100% Analogue Circuit for the extra depth, clarity and warmth. Apart from the single core issue (which theyre addressing in soon to be released v3). This service sits as a bridge from final mixdown and final master. ![]() At Woodlands Studios, we believe that adding that 15% to polish off a mix ahead of Mastering is essential.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |